RMAN-P4T-001 rev. A • P4T/RP4T Repair Procedures • 2-30 •
Installing the Peeler Assembly
1. Connect the Peeler Sensor Cable such that the white line on the end of the
cable is visible.
2. Place the two (2) springs in place over the plastic posts on the Media Cover.
3. Insert the boss on the left side of the Peeler Door in the corresponding hole
on the Media Cover. Press down over the two springs and snap the right side
in place.
4. Insert one end of the Peeler Bar in the hole on the right side of the printer
above the Platen Roller as shown. Snap the other end of the Peeler Bar in the
slot on the left side of the printer. Make sure it rolls freely once installed.
To Next Page
Loading...
