• 2-31 • RMAN-P4T-001 rev. A • P4T/RP4T Repair Procedures
Removing the Clutch Take-up and Clutch Supply Assemblies
Both the Clutch Take-up and Clutch Supply Assemblies are spring loaded and made
up of multiple parts and therefore require the user to be careful during removal and
installation.
1. Remove the Upper Housing from the Lower Housing.
2. Unplug the Latch Switch (p/n BL14039-2) connector located next to the Motor
Cable connector on the main logic board at J19.
3. Remove the three (3) self-tapping screws highlighted below and lift off the
Gear Retainer (p/n BA18563-1) exposing the Clutch Take-up and Clutch Supply
assemblies.
Replacement Kits RK18931-008 & 009- Clutch Take-up and
Clutch Supply Assemblies
Installation Instructions
This kit includes the parts and documentation necessary to install the
RK18931-008 and 009 Clutch Take-up and Clutch Supply Assemblies for the RP4T/
P4T model printers. Read these instructions thoroughly before attempting to install
this kit.
Tools Required
#0 or #1 Phillips Head Screw Driver
To Next Page
Loading...
