RMAN-P4T-001 rev. A • P4T/RP4T Repair Procedures • 2-32 •
4. Locate the Clutch Take-up Assembly (as shown) and lift the assembly from the
printer frame. Repeat the process for the Clutch Supply Assembly.
Installing the Clutch Take-up and Clutch Supply Assemblies
1. Insert the Clutch Take-up Assembly over the plastic boss on the printer frame
next to the motor pinion gear.
2. Insert the Clutch Supply Assembly over the plastic boss located next to the
Clutch Take-up Assembly. Ensure that the flat edge on the bottom portion of
the gear is lined up with the flat part of the plastic in order to seat properly.
3. Use the three screws to secure the Gear Retainer Cover to the printer frame.
4. Reassemble the Upper Housing to the Lower Housing.
To Next Page
Loading...
