RMAN-P4T-001 rev. A • P4T/RP4T Repair Procedures • 2-34 •
Installing the Latch Switch Assembly
1. Align the Latch Switch Assembly with the plastic posts on the Gear Retainer
and slide it into place.
2. Secure the assembly with the washer and self-tapping screw.
3. Attach the Gear Retainer to the printer frame with three self-tapping screws.
4. Route the Latch Switch cable within the plastic guides located on the printer
frame below and next to the gear retainer cover as illustrated below.
5. Plug the Latch Switch cable to the J19 connector on the main logic board as
shown below.
To Next Page
Loading...
