Zebra P4T Installation Guide

12
P4T Vehicle Cradle Installation Guide
Secure the Power Cable
Make sure that the cable routing does not interfere with other
equipment or vehicle controls. Insure that the cable routing pro-
tects the cable from damage during vehicle use.
Using the Printer in the Vehicle Cradle
Printer Preparation
Prepare the printer for installation into the Vehicle Cradle by do-
ing the following:
It is strongly recommended as a safety precaution that the adjustable shoul-
der strap be removed prior to docking the Printer. This precaution will en-
sure the strap will not interfere with proper operation of the vehicle.
Always install the Battery prior to mounting the printer in the •
Cradle.
Remove the Docking Connector Cover from the bottom of the •
printer, and retain it for future use. (Refer to Figure 4)
Printer Installation
The P4T Printer can now be installed in the Vehicle Cradle:
Figure 4: Printer Preparation
Remove and retain the
Docking Connector
Cover and attaching
Hardware

Zebra P4T Specifications

General

Color	No
Maximum resolution	203 x 203 DPI
Core diameter	19 mm
Ribbon length	29992.3 m
Media thickness	0.08 - 0.22 mm
Maximum roll diameter	66 mm
Media thickness (imperial)	0.0032 - 0.0085 \
Bluetooth	Yes
Connectivity technology	Wireless
Battery capacity	4200 mAh
Weight (imperial)	2.9 lbs
Dimensions (WxDxH)	165.9 x 85.9 x 220.5 mm
Flash memory	8 MB
Internal memory	16 MB
Built-in barcodes	Code 39, Code 93, MaxiCode, QR Code, UPC-A, UPC-E
Page description languages	CPCL-native, EPL, EPL2, XML, ZPL
Storage temperature (T-T)	-22 - 149 °F
Operating temperature (T-T)	0 - 45 °C
Operating relative humidity (H-H)	10 - 90 %
Package weight	1900 g