Zebra P4T Installation Guide

13
P4T Vehicle Cradle Installation Guide
Place the bottom of the printer over the two pegs in the •
Cradle.
Rotate the Printer into the Cradle and press fi rmly until it •
latches in place.
Turn the vehicle’s power source for the Cradle on, and verify •
that the charger indicator on printer LCD and power indicator
light on the Cradle’s side panel are lit.
Turn the printer on and print a confi guration label to verify •
that the printer is functioning properly. Refer to the P4T
User’s Guide for instructions on printing a confi guration label.
Removing the Printer
Remove the Printer by doing the following:
Turn the Printer off.•
If the Printer is directly connected to a communications ca-•
Figure 5: Installing the Printer In The Vehicle Cradle
Place the Printer over
the retaining pins in
the Cradle.
Rock the Printer into the
Cradle to latch it in position.

Zebra P4T Specifications

General

Color	No
Maximum resolution	203 x 203 DPI
Core diameter	19 mm
Ribbon length	29992.3 m
Media thickness	0.08 - 0.22 mm
Maximum roll diameter	66 mm
Media thickness (imperial)	0.0032 - 0.0085 \
Bluetooth	Yes
Connectivity technology	Wireless
Battery capacity	4200 mAh
Weight (imperial)	2.9 lbs
Dimensions (WxDxH)	165.9 x 85.9 x 220.5 mm
Flash memory	8 MB
Internal memory	16 MB
Built-in barcodes	Code 39, Code 93, MaxiCode, QR Code, UPC-A, UPC-E
Page description languages	CPCL-native, EPL, EPL2, XML, ZPL
Storage temperature (T-T)	-22 - 149 °F
Operating temperature (T-T)	0 - 45 °C
Operating relative humidity (H-H)	10 - 90 %
Package weight	1900 g