RS5100 Quick Start Guide
8
Powering On
To power on the device:
1. Install the battery (if not already installed).
NOTE: Brand new batteries from the factory are shipped in Ship Mode for protection, and need to be plugged into a charger
(cradle or battery toaster) to activate the battery.
2. Press one of the following:
• side scan trigger on the single trigger
• left side scan trigger on the double trigger
• scan trigger on the lanyard
• scan trigger on the back of hand mount.
Bluetooth Connection
NOTE: The connection methods below apply only to Zebra Mobile Computers. For more information, refer to the RS5100 Product
Reference Guide.
NFC Tap-to-Pair
The RS5100 is NFC enabled and supports Bluetooth Tap-to-Pair.
To connect with a device, such as the WT6000 or TC52:
1. Check that NFC is enabled on the device.
2. Align the NFC icon on the RS5100 with the NFC icon on the device.
The Status LED blinks blue indicating that the RS5100 is attempting to establish connection with the device.
When a connection is established, the Status LED turns off and the RS5100 emits a single string of low/high
beeps.
MN-003559-02EN_rs5100-qsg-en.fm Page 8
To Next Page
Loading...
Need help?
General
