Need help?Do you have a question about the Zebra CS6080 Series and is the answer not in the manual?
General| Scan Pattern | Omni-directional |
|---|---|
| Connectivity | Bluetooth, USB |
| Sealing | IP65 |
| Scan Engine | SE4710 |
| Interface | USB, Bluetooth |
| Ingress Protection Rating | IP65 |
| Drop Specification | 1.8 m (6 ft) to concrete |
| Operating Temperature | -20°C to 50°C (-4°F to 122°F) |
| Decode Capability | 1D, 2D, PDF417 |
| Storage Temperature | -40° to 158° F / -40° to 70° C |
| Humidity | 5% to 95% (non-condensing) |
Details the Standard Range (SR) and Healthcare (HC) versions of the CS6080 scanner.
Identifies components of the cordless CS6080 scanner's front view.
Identifies components of the corded CS6080 scanner's front view.
Details NFC, release latch, and finger grip recess on the scanner's bottom.
Barcodes for setting defaults and adding a Tab key to scanned data.
Barcode to append an Enter key (Carriage Return/Line Feed) after scanned data.
Barcode to enable or disable USB Caps Lock override functionality.
Barcodes to enable, disable, or toggle Night Mode with vibrate.
Step-by-step guide for inserting the battery into the scanner.
Step-by-step guide for removing the battery from the scanner.
Instructions on how to install the corded USB converter cable.
Instructions for inserting and removing the corded USB converter cable.
General information on how to charge the cordless scanner.
How to charge the scanner in a standard cradle.
How to charge the scanner in a healthcare presentation cradle.
Details cable connections for standard and healthcare cradles.
Instructions for charging the scanner using a charging pad.
Barcodes for USB connection modes (IBM OPOS, SNAPI).
Configuration for IBM OPOS and SNAPI connections.
Overview of Bluetooth profiles (Cradle, HID, SSI, SPP).
Barcodes for Cradle Bluetooth Classic and Low Energy.
Barcodes for HID Bluetooth Classic and Low Energy.
Barcodes for SSI BT Classic (Discoverable/Non-Discoverable) and SSI BT LE.
Barcode for SSI BT with MFi (iOS) support.
Barcodes for SPP BT Classic (Non-Discoverable & Discoverable).
How to aim the scanner at the barcode and press the scan button.
Visual and auditory cues for successful barcode scanning.
Actions associated with single/double press and holding the scan button.
Actions for single press options of the programmable button.
LED status for successful decode and errors.
LED status for battery charge level and charging errors.
LED status for Bluetooth pairing and connection.
Introduction to the PC-based software tool for scanner setup.
Lists device configuration, programming, data view, and firmware upgrade features.
Solutions for aiming pattern and barcode decoding failures.
Solutions for data not transmitting or displaying incorrectly.
Solutions for when the scanner does not fully charge.
Solutions for when the Bluetooth LED turns off.
Solutions for when the scanner emits long beeps due to full memory.
Information on compliance with human exposure to electromagnetic fields.
Ergonomic recommendations for safe workplace practices.
Precautions for wireless devices in sensitive environments.
Information on Zebra approved batteries and safety guidelines.
Details on reducing RF exposure and accessory compliance.
Statement of compliance with EU directives and CE marking.
Recycling and disposal advice for electronic equipment.
FCC and Canadian notices regarding radio frequency interference.
Notes on FCC Part 15 compliance for Class B digital devices.
Compliance with Canadian ICES-003 and RSS standards.
Information on SAR levels and FCC equipment authorization.
How to contact support for facility or global issues.
Details on the complete Zebra hardware product warranty.
Specific warranty terms for Australian customers.
To Next Page