EasyManua.ls Logo

Zebra CS6080 Series - General Product Safety

Zebra CS6080 Series
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
26 CS6080 Scanner
To charge the mobile device battery, the battery and charger
temperatures must be between
0°C and +40°C (+32°F and +104°F).
Do not use incompatible batteries and chargers. Use of an
incompatible battery or charger may present a risk of fire,
explosion, leakage, or other hazard. If you have any
questions about the compatibility of a battery or a charger,
contact Zebra support.
Do not disassemble or open, crush, bend or deform,
puncture, or shred. Damaged or modified batteries may
exhibit unpredictable behavior resulting in fire, explosion, or
risk of injury.
Severe impact from dropping any battery-operated device on
a hard surface could cause the battery to overheat.
Do not short circuit a battery or allow metallic or conductive
objects to contact the battery terminals.
Do not modify, disassemble, or remanufacture, attempt to
insert foreign objects into the battery, immerse or expose to
water, rain, snow or other liquids, or expose to fire, explosion,
or other hazard.
Do not leave or store the equipment in or near areas that
might get very hot, such as in a parked vehicle or near a
radiator or other heat source. Do not place battery into a
microwave oven or dryer.
To reduce the risk of injury, close supervision is necessary
when used near children.
Please follow local regulations to promptly dispose of used
re-chargeable batteries.
Do not dispose of batteries in fire. Exposure to temperatures
over 100°C (212°F) may cause explosion.
Seek medical advice immediately if a battery has been
swallowed.
In the event of a battery leak, do not allow the liquid to come
in contact with the skin or eyes. If contact has been made,
wash the affected area with large amounts of water and seek
medical advice.
If you suspect damage to your equipment or battery, contact
Zebra support to arrange for inspection.
Do not use a power pack in excess of its output rating.
Overload outputs may result in risk of fire or injury to persons.
Have service performed by a qualified Zebra service center.
This will ensure safety of the product is maintained.
WARNING: When using this product basic safety
precautions should always be followed, including
the following:
The area in which the units are charged should be
clear of debris and combustible materials or
chemicals. Particular care should be taken where
the device is charged in a non-commercial
environment.
Read all the instructions before using the
product.
Follow battery usage, storage, and charging
guidelines found in the user's guide.
Improper battery use may result in a fire,
explosion, or other hazard.

Related product manuals