30 CS6080 Scanner
Radio Frequency Interference
Requirements- Canada
Innovation, Science and Economic Development Canada
ICES-003 Compliance Label: CAN ICES-3 ([B])/NMB-3([B])
This device complies with Innovation, Science and Economic
Development Canada’s licence-exempt RSSs. Operation is
subject to the following two conditions: (1) This device may
not cause interference; and (2) This device must accept any
interference, including interference that may cause undesired
operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le
présent appareil est conforme aux CNR d’Innovation,
Sciences et Développement économique Canada
applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radio
électrique subi même si le brouillage est susceptible d'en
compromettre le fonctionnement.
RF Exposure Requirements - FCC
and ISED
The FCC has granted an Equipment Authorization for this
device with all reported SAR levels evaluated in compliance
with the FCC RF emission guidelines. SAR information on
this device is on file with the FCC and can be found under the
Display Grant section of www.fcc.gov/oet/ea/fccid
.
NOTE: This equipment has been tested and
found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the
equipment and receiver
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected
• Consult the dealer or an experienced radio/TV
technician for help.
To Next Page
Loading...
Need help?
General
