ZvSync-NA User’s Manual
|
Page 11
To program a key the following sequence shall be executed:
Step1: Press and hold the “SET” button for three seconds
The RED LED lights immediately when the button is pressed
After 3 seconds the LED changes to a very bright state
Step 2: Press the key you wish to program (P1-P5)
The RED LED changes to a slow ash (1/second)
Step 3: Press the key on the remote that you are copying
The RED LED performs three quick ashes to acknowledge
RED LED turns on solid again.
Repeat steps 2 and 3, or simply wait for light to extinguish
Step 4: Test Programmed key on television or device to be controlled
If command is not executing properly, repeat steps 1-3
To Next Page
Loading...