Zeliox ECO - Page 24

Dry contact 2
When the built-in Booster Charger starts charging it will activate the output
relay dry contact for simulates the engine start signal.
When the built-in Booster Charger stops charging, it will break the relay
output dry contact.
Dry contact 3
The default setting of SOC
≥5% (5%~50% can be set) will activate the output relay dry contact for
starting the power distribution module.
≤0% (0%~45% can be set) will break the relay output dry contact.
Figure 3-6 Dry contact 2
Figure 3-7 Dry contact 3
24