Zeliox ECO - Faq

7 FAQ
Type
Times
of ALM
light
flashes
Name
Processing suggestions
Fault
protection
1
Output short
circuit
protection
 Please check that the 12V
Output or M12-100/P(M12-200/H)
positive and negative connections are not
reversed or short-circuited.
 If there is no wiring error,
please contact your dealer.
2
Discharge
over current
protection
 Check that the discharge
current of the ECO does not exceed the
rated discharge current, if it does, switch
off part of the load.
 If the discharge current does
not exceed the rated discharge current,
please contact your dealer.
3
Charging
over current
protection
 Please contact your dealer.
4
General low
voltage
protection
 The battery capacity is already
low, please recharge the ECO
immediately.
5
Cell low
voltage
protection
 The battery capacity is already
low, please recharge the ECO
immediately.
6
General high
voltage
protection
 Please contact your dealer after
switching off the charger.
7
Cell high
voltage
protection
 Please contact your dealer after
switching off the charger.
32