Zeliox ECO - Page 33

33
Type
Times
of ALM
light
flashes
Name
Processing suggestions
Fault
protection
8
Discharge
high
temperature
protection
 Please check that the ambient
temperature at the ECO installation
location is not too high.
 Please check that the wire diameter of
the ECO cable meets the requirements of
the manual.
 Please check that the discharge current
and discharge time of the ECO do not
exceed the specified requirements.
 If these are normal, please contact your
dealer.
9
Discharge
low
temperature
protection
 Please check if the ambient temperature
at the ECO installation location is below -
20°C. If so, please connect the alternator
(grid) to 12V Input (230V Input) to raise
the temperature of the lithium battery
inside the ECO by heating the heating
film inside the ECO.
 If this still does not solve the problem,
please contact your dealer.
10
Charging
high
temperature
protection
 Please check that the ambient
temperature at the ECO installation
location is not too high.
 If this is correct, please contact your
dealer.
11
Charging low
temperature
protection
 Please check if the ambient temperature
at the ECO installation location is below
2°C. If so, please connect the
alternator(grid) to 12V Input(230V Input)
to raise the temperature of the lithium
battery inside the ECO by heating the
heating film inside the ECO;
 If this still does not solve the problem,
please contact your dealer.
12
BMS circuit
high
temperature
protection
 Check that the ambient temperature at
the ECO installation location is not too
high.
 Please check that the discharge current
and discharge time of the ECO do not
exceed the specified requirements.
 If the above is correct, please contact
your dealer.
33