Zelmer Flooris - Vacuum Cleaner VC1006 Types; Appliance Elements Overview; Preparing for Operation

52 VC1006-003_v01
Delicate and soft natural bristles ensure maximum vacuum
effectiveness and protects against scratching the cleaned
surface.
20
Small nozzle
21
Small brush
22
Crevice nozzle
23
Switchable combination brush
24
Turbobrush (only in models VC1006.0HT and
VC1006.0ST)
25
Accessory holder
26
Holder screws
Preparing the vacuum cleaner
for operation
1
Insert the curved hose end in the opening of the vacuum
cleaner and gently press. A characteristic click indicates that
the hose has been properly installed.
2
Connect the other end of the hose (handle) with the
telescopic suction tube. In order to do so press the locking
device “A” and slide the tube into the hose handle so that
the locking device “A” is blocked in opening “B”.
3
Adjust the length of the telescopic suction tube by sliding
the slider according to the arrow and pull out/ pull the tube
together.
4
Assemble the appropriate nozzle or brush to the other
end of the suction tube.
5
To clean hard surfaces – wooden oors, plastic oors,
ceramic tiles etc. pull out the brush by pressing the switch on
the combination brush according to the gure .
6
The accessories may be attached to the accessory
holder in the suction hose handle. This way they will be
available for use at any time.
B
VACUUM CLEANER VC1006 TYPES
Workmanship
and
equipment
option
Type
Suction power regulator
Overheating protection
Safety valve
Parksystem „Auto-start”
Bag loading indicator
No bag protection
Dust bag / amount
Outlet lter
Suction tube
Combination brush
Small nozzle
Crevice nozzle
Small brush
Turbo brush
Parquet brush “BNB”
1 2 4 5 6 7 8 9 10 11 12 13 14 15 16 17
VC1006.0HP + + + + + + SAFBAG 2 pieces HEPA H13 Telescopic + + + + – +
VC1006.0ST + + + + + + SAFBAG 2 pieces HEPA H11 Telescopic + + + + + –
VC1006.0HT + + + + + + SAFBAG 2 pieces HEPA H13 Telescopic + + + + + +
Appliance elements
A
1
Cord rewind button
2
Combination brush fastening
3
Plug and cord
4
Filter cover release button
5
Outlet lter cover
6
Suction power regulation slider
7
Dust bag full indicator
8
ON/OFF button
9
Handle
10
Front cover fastening
11
Slider – mechanical suction power regulator
12
Suction hose
13
Telescopic suction tube
14
SAFBAG dust bag
15
SAFBAG dust bag module (with the installed SAFBAG
dust bag)
16
Outlet lter. The vacuum cleaner is tted with only one
outlet lter (A or B)
A
HEPA H11 outlet lter (only in model VC1006.0ST)
(installed in the vacuum cleaner)
B
HEPA H13 outlet lter (only in models VC1006.0HT
and VC1006.0HP) (installed in the vacuum cleaner)
17
Inlet lter casing (installed in the vacuum cleaner)
18
Inlet lter (installed in the vacuum cleaner)
19
Parquet brush “BNB” (Brush Natural Bristle) (only in
models VC1006.0HT and VC1006.0HP)
Is used to clean and polish hard, scratch sensitive surfaces
such as wooden oors, oor panels, parquet, marble, tiles, etc.