Zenair CH2000 - Page 20

TABLE 1 – ZENAIR INSPECTION FORM
Make / Model
ZENAIR CH2000
Serial No.
Airframe Hours
Type of Inspection
(Circle One)
Registration No:
Engine Hours
50 100 500 1000
Symbols: + Indicates perform task, - Indicates do not perform task
Task
Refer to
Intervals
(Flight Hours)
Initials
50
100
500
1000
14. Inspect engine for security of all
attaching hardware (nuts, bolts, screw,
etc.)
15. Perform valve clearance check
16. Inspect the ignition harnesses for
general condition.
17. Inspect the carburetor air intake box for
leaks.
18. Drain carburetor and clean carburetor
fuel strainer and strainer bowl.
19. Inspect engine cowlings for cracks,
damage, loose rivets, etc.
20. Inspect the vacuum pump, lines and
separator,
21. Change the Oil filter.
22. Inspect the oil radiator, oil lines and
attaching brackets.
23. Clean and flush oil radiator.
24. Inspect engine, firewall and firewall
seals for deterioration, cracking, etc.
25. Inspect cabin heat control box for
cracks, condition, etc.
26. Inspect engine controls for defects,
safeties, etc. Check control travels.
27. Check starter, alternator, fuel pump
and vacuum pump for proper mounting,
security and defects
28. Perform operational checks of all
systems (fuel, oil, heating, etc.)
Lycoming Operator’s
Manual Section 5 and
Lycoming Service
Instruction March 17
1997
Section VI
Section VI
Section VI
Section VI
Section VI
Section XI
Section VI
Section VI
Section VI
-
-
+
+
-
+
-
+
+
-
-
+
-
-
-
+
+
+
+
+
+
+
+
+
-
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
3.4 Nov-02