ZENAIR CH2000 SERVICE MANUAL
________________________________________________________________________
SECTION II
HANDLING AND SERVICING
GENERAL
This section provides ground handling and servicing instructions.
Recommended ground handling procedures, and recommended methods of servicing
are provided in following paragraphs. If trouble or damage to the aircraft is discovered
during ground handling or servicing, refer to the appropriate section for the system
concerned. Lubrication is treated as a separate function.
ACCESS PROVISIONS - Fig. 2
The figure shows the location and identity of the access doors and panels that provide
access for purposes of service and maintenance.
GROUND HANDLING
GENERAL. The aircraft must not be pushed, pulled, or lifted by any other means than
those described. Procedures are given for the proper execution of all necessary handling
operations and, if the instructions are followed, damage to the aircraft or its equipment
will be prevented.
Caution: Use the utmost care at all times during ground handling operations.
STEP, HANDHOLD, AND WALKWAYS
A fixed step is located on each side, below and aft of the inboard end of the wing trailing
edge and fixed handholds are located on the sides of the fuselage, above the aft upper
corner of the rear window. The walkway is made up of a non-skid compound applied to
the wing surface.
Caution: Walk on the walkways only, to avoid damage to the wings.
3 Apr 95 2.1
To Next Page
Loading...