Zendure AIO 2400 User Manual


EN
9. Keep a distance of 50mm between AIO 2400 and other objects.
10. During the operation of the solar energy system, avoid direct sunlight to prevent the AIO 2400 from
overheating. Do not place the AIO 2400 near any heat source.
11. Please install the product according to our user manual to avoid damage to the product or injury to other
people.
12. 
13. 
Since AIO 2400 relies on the shell to dissipate heat, exposing the enclosure to excessive heat will lead to
damage.
14. To reduce risk of damage to the electric cords and connectors, pull the connectors rather than the cord
when disconnecting the product.
15. 
persons.
16. 

17. Do not operate the product with a damaged cord or plug, or a damaged output cable.
18. 

19. 
20. Do not attempt to replace the internal components of the equipment by any unauthorized personnel. Have

the safety of the product is maintained.
21. AIO 2400 has a protection level of IP65, so the product cannot be immersed in liquids. If the product
accidentally falls into water during use, please place it in a safe and open area and stay away from it until it
is completely dry. The dried product should not be used again and should be properly disposed of according
to the disposal guidelines in this manual.
22. When charging a device, the product may feel warm. This is a normal operating condition and should not be
a cause for concern.
23. To reduce the risk of electric shock, unplug the power pack from the outlet before attempting any instructed
servicing.
24. When charging the internal battery, work in a well-ventilated area and do not restrict ventilation in any way,
as inadequate ventilation may cause permanent damage to the equipment.
25. 
disconnected.
26. Do not clean the product with harmful chemicals or detergents. Only clean the ports with a dry cloth.
27. Do not move or shake the unit while operating as vibrations and sudden impacts may lead to poor
connections to the hardware inside.
28. Ensure that AIO 2400 and the Microinverter are installed securely to avoid accidents and product damage
caused by falling.
29. 
30. Servicing of batteries should be performed or supervised by personnel knowledgeable about batteries and
the required precautions.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
1.2 FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1 ) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
2. 
user's authority to operate the equipment.

Zendure AIO 2400 Specifications

General

Brand	Zendure
Model	AIO 2400
Category	Storage
Language	English