Need help?Do you have a question about the ZENEC ZE-NC2011D and is the answer not in the manual?
General| Brand | ZENEC |
|---|---|
| Model | ZE-NC2011D |
| Category | Car Video System |
| Language | English |
Connect main harness to CAN/Stalk interface and 8-pin connector to ZE-NC2011D.
Check for angled FM Fakra plug; a double Fakra extension lead may be required.
Prepare ZE-NC2011D, connect main harness, and CAN/Stalk interface.
Carefully remove the plastic trim frame surrounding the OE radio using a panel tool.
Unscrew the four Torx screws, pull out the OE radio, and detach all cables.
Install GPS antenna, route cables, connect Quadlock, Fakra, and microphone.
Tuck wires, slide ZE-NC2011D into the bay, and secure with original screws.
Reattach trim frame, start engine, drive to open for GPS, and allow satellite fix.
Disconnect the negative battery pole before installation to prevent error codes.
Ensure flawless function by exclusively using the supplied accessories.
Protect cables from damage by sharp edges and avoid excessive force during installation.
Adjust BT microphone source in the Setup Menu based on internal or external mic choice.
Check all rear plug-and-socket connections are properly seated before final mounting.
Contact ZENEC dealer or www.zenec.com for FAQs and technical assistance.
Install Media Link Box for accessible USB port for software and map updates.
To Next Page
