Zenith Allegro - Page 17

15
'
14)
into the Tape
Slot.
When
the Cartridge
is
firmly seated
and locked-in, one of the Program Indicator Lights will be
illuminated to
indicate the Program
on which you
are
recording. The Record LEVEL Meters
will
be
illuminated
and
indicate the relative recording level.
5. The
RECORD
LEVEL Controls should
be
adjusted
so
that
the
pointers
of the Record LEVEL Meters
will
enter the
Red area of the Meters
only occasionally,
on loud sounds.
6. Set the Tape Mode Switch
to
CONT. Push PROGRAM
Selector Button and repeat until desired recording area
is
reached. Reset Tape Mode Switch
to EACH or 4 position.
7.
To begin
recording, release the PAUSE Button (See page
13,
#6),
8. If the material that
you
are recording is longer than the
length of one
program,
be
sure to place the Tape Mode
Switch in the
"4"
or Xont." mode.
WARNlNGi
When you have
recorded all
4
programs
-
STOP.
Otherwise, the unit will go on to the next
program
and erase
your previous recording by
recording
over it.
9.
When
you
are finished
recording,
use
the PAUSE
Button
to
stop tape movement
and remove
the cartridge
from the
Tape
Slot. Release
PAUSE Button.
Move
the POWER
Switch
on main
unit to OFF.
This will
turn off the
power to
the
entire
unit. The tape cartridge
should be pulled
com-
pletely
out of
the
unit when not
being used.
ERASING
RECORDINGS
When
a new
recording
is made, the previous
recording is
automatically
erased. In
this way
cartridges may
be re-used
as
often
as desired.
To erase
a cartridge
without making
a new recording
proceed as follows:
Move POWER
Switch
to
ON, (Fig.
1)
1.
Move
the FUNCTION
Selector
to the
TAPE
position. (Fig.
1)
2.
Disconnect
the
Microphones from
the MIC INPUT
Jacks.
3.
Move
the RECORD
LEVEL Controls
all the way
to
the left.
4. While
depressing
the
RECORD
Button insert
the cartridge
that
you wish
to erase.
When
recording,
any blank or previously
recorded
tape
should
be indexed
to the program
change
point. This
point
can
then
be used as a
reference point
for
your
recordings.
Examine
the
tape which
is visible
through the opening
of the
cartridge.
If the metallic
sensing
tape
cannot
be seen, set
the Tape Mode
Switch
to
the
4
position
and insert
the car-
tridge.
Press the
PROGRAM
Selector
Button repeatedly
to