Zenoah GZ3500T User Manual

To change a broken recoil spring
1. Lift up the starter pulley. See instructions under the
heading
To change a broken or worn starter cord on
page 24
2. Remove the cassette with the recoil spring from the
starter.
WARNING: Remember that the recoil
spring is coiled under tension in the
starter housing!
3. Lubricate the recoil spring with light oil and fit the
cassette with recoil spring in the starter.
4. Fit the starter pulley and tension the recoil spring. To
learn more about how to tension the recoil spring,
see heading
To tension the recoil spring on page
25
To learn more about how to fit the starter on the
chainsaw, see heading To fit the starter on the chainsaw
on page 25
To tension the recoil spring
1. Hook the starter cord in the notch in the pulley.
2. Turn the starter pulley about 2 turns clockwise.
Note:
Make sure that the pulley can be turned at least a
1/2 turn further when the starter cord is pulled all the way
out.
3. Stretch the line using the starter handle.
4. Move your thumb and release the line.
To learn more about how to fit the starter on the
chainsaw, see heading
To fit the starter on the chainsaw
on page 25
To fit the starter on the chainsaw
1. Pull out the starter cord and place the starter in
position against the crankcase.
2. Slowly release the starter cord so that the pulley
engages with the pawls.
3. Tighten the screws that hold the starter.
To clean the air filter
The air filter must be regulary cleaned to remove dust
and dirt in order to avoid:
• Carburettor malfunctions.
• Starting problems.
• Loss of engine power.
• Unnecessary wear to engine parts.
• Excessive fuel consumption.
1. Lift up the cylinder cover.
2. Remove the air filter.
3. Brush or shake the air filter clean. Wash it in
detergent and water to clean it more thoroughly.
Note:
An air filter that has been in use for a long time
can't be clean completely. The filter must therefore
be replaced with a new one at regular intervals.
Always replace a damaged air filter.
4. Refit the air filter and make sure that the air filter
seals tightly against the filter holder.
A Zenoah chainsaw can be equipped with different types
of air filter according to working conditions, weather,
season etcetera. Contact your servicing dealer for
advice.
308 - 004 - 27.09.2017
25

Zenoah GZ3500T Specifications

General

Brand	Zenoah
Model	GZ3500T
Category	Chainsaw
Language	English