Name: Zephyr AK7636AS
Brand: Zephyr
Rating: 4 (1 reviews)

Questions and Answers:

A
Angela OneillAug 2, 2025
Why does the blower on my Zephyr AK7636AS turn on by itself?
- P
  Paul TannerAug 2, 2025
  The clean air function might be enabled, turning the blower on every 4 hours. To resolve this, disable the clean air function by following the steps on page 14.
V
vcruzAug 6, 2025
Why is my Zephyr Ventilation Hood not venting out properly?
- L
  Lori LewisAug 7, 2025
  If your Zephyr Ventilation Hood isn't venting properly, several factors could be at play. First, ensure the hood is correctly positioned between 24 and 34 inches above the cooktop. External elements like open windows or doors can disrupt airflow, so close them to minimize wind interference. Check for any obstructions in the duct opening or ductwork and clear them away. The direction of the duct opening relative to the wind can also matter, so adjust it as needed. Finally, verify that you're using the correct ducting size and replace it if necessary.
S
smithandrewAug 12, 2025
What to do if the light works, but the blower is not turning on my Zephyr AK7636AS?
- A
  Alex BerryAug 12, 2025
  If your Zephyr Ventilation Hood's light is working but the blower isn't, there are a few potential reasons. The blower itself might be defective or seized, in which case it should be replaced. The thermally protected system may have shut down the blower due to overheating; it will function normally once cooled down. A damaged capacitor could also be the culprit, requiring replacement. Lastly, check that the blower wire is securely plugged into the molex connector.

Zephyr AK7636AS Specifications

General

Brand	Zephyr
Model	AK7636AS
Category	Ventilation Hood
Airflow	600 CFM
Lighting	LED
Material	Stainless Steel
Filter Type	Baffle
Width	36 inches
Control Type	Touch
Duct Size	6 inches
Venting Size	6 inches