On FLX, syntax can be used in the fixture schedule to select, readdress, and also delete fixtures.
Syntax addressing
When readdressing fixtures, the syntax format is fixture number @ address Enter :
1 @ 2 7 4 Enter
1, @ 274
“Fixture 1” will be patched to DMX address 274 on Universe 1.
A specified universe can be defined by adding the universe number before the start address, separated by a point:
1 @ 2 . 1 5 6 Enter
1, @ 2. 156
“Fixture 1” will be patched to DMX address 156 on Universe 2.
Group Patching is performed sequentially from a given start address. This results in all of the fixtures of this type being
assigned one after another starting at the address you define. For example:
Group 1 @ 3 . 1 Enter
Group 1, @ 3. 1
The first fixture in Group 1 will be patched at DMX address 1 on Universe 3. All other fixture start addresses will
increase sequentially until the whole group has been patched or the universe is full.
Syntax Deleting
5 Delete
5, Delete
Fixture 5 will be permanently deleted
1 0 Thru 1 5 Delete
10 Thru 15, Delete
Fixtures 10 through to 15 inclusive will be permanently deleted.
Deleting Fixtures
Zero 88 - ZerOS - Page 54 of 233 Printed: 23/11/2020 12:50:03 JH
To Next Page
Loading...
Need help?
General
