Intensities can be stored in groups, and recalled by double tapping a group, or by using Intensity Group syntax on FLX.
When a fixture is taken to its full level within an Intensity Group, and then recorded into a cue, ZerOS references the
value back to the group’s intensity, not the raw intensity values. So if the intensities in the group are updated, any cues
that were recorded using that group, will automatically be updated to the new intensity too.
This is sometimes referred to as Intensity Palettes. Therefore on ZerOS, Groups and Intensity palettes are combined.
Upon recalling an intensity group, the reference is displayed on the
intensity encoder wheel. For example recalling the intensities of group
1, which contains fixture's at 50%, would display "I1 (50)", where I1
stands for Intensity palette 1, and the raw intensity percentage is
displayed in brackets.
Naming Groups
Groups can be named by holding Setup and pressing the Group on the touchscreen. An onscreen keyboard will then
be displayed to type the group’s name. Press OK to confirm.
Zero 88 - ZerOS - Page 67 of 233 Printed: 23/11/2020 12:50:03 JH
To Next Page
Loading...
Need help?
General
