FLX range lighting consoles feature award winning colour control. All colour parameters of your fixtures can be
controlled using the colour attribute encoder wheels, accessed by selecting the fixture and tapping Colour . If your
fixtures have more parameters than available encoders, tap the Colour button again to page through.
As well as using encoders, FLX range consoles also support multiple methods of choosing colours, for fixtures with
colour mixing capabilities. The colour mixing will be applied to fixtures with RGB, RGBW and CMY colour control. All
other parameters can be accessed using the encoder wheels. If using CMY fixtures, the encoder wheels will by default
display Red, Green and Blue parameters on the encoders, and the console will do the work to convert this to CMY to
output to your fixtures. If you would prefer to work with CMY encoders, open the Colour Settings, by pressing and hold
Setup, and tapping Colour. You can then change the Colour Edit Mode to CMY.
Find out more about the colour controls...
Colour Palettes
Colour Picker
Colour Faders
Colour Filters
Fixtures that can colour mix, can use two methods - subtractive colour mixing, or additive colour
mixing. Take a look at the videos below for more information...
Subtractive Colour Mixing.
Additive Colour Mixing.
Palettes
Colour palettes can be automatically created, when you have fixtures
with colour mixing or colour wheels patched.
Zero 88 - ZerOS - Page 74 of 233 Printed: 23/11/2020 12:50:03 JH
To Next Page
Loading...
Need help?
General
