General Operation
4.15
7. Bounce the suspension a couple of times.
8. Have a second assistant take a measurement using the same
locations as in step 2.
9. Record this measurement (this is the measurement referred
to as M2).
10. Subtract the second measurement (M2) from the first
measurement (M1).
Example:
The total sag is 1.97 in (50 mm). Refer to the chart below for the
correct sag. If the sag is not correct, the spring preload should
be adjusted.
Measurement Operator Value
M1 23.62 in (600 mm)
M2 - 21.65 in (550 mm)
Sag = 1.97 in (50 mm)
MODEL SAG
S & SR 1.77 in (45 mm)
DS & DSR 2.36 in (60 mm)
Zero Owner's Manual (S and DS).book Page 15 Monday, September 21, 2020 11:43 AM
To Next Page
Loading...
