General Operation
4.16
Spring Preload Adjustment
1. Clean any dirt or debris from the slots of the shock adjusting
collar (A).
2. Using an adjusting wrench, turn the adjusting collar (A).
3. For measurements less than the specified value, decrease
the preload on the spring by turning the adjustment collar
counter-clockwise on the shock. If more than the specified
value, increase the preload on the spring by turning the
adjustment collar clockwise on the shock.
Rebound Adjustment
The rebound adjuster knob (A) is at the bottom of the shock.
Printed on the knob is “H” meaning Hard (MAX, which is for
slower rebound) and “S” meaning Soft (MIN, which is for faster
rebound). The ride quality adjustment knob controls the
hardness or softness the ride quality of your motorcycle. Turning
the knob clockwise, or H direction, is good for big impacts.
Turning the knob counter-clockwise, or S direction, is good for
smaller and more frequent impacts.
Note: Adjusters should never be forced completely “Soft” or
“Hard”; always leave one click of adjustment in either direction.
Zero Owner's Manual (S and DS).book Page 16 Monday, September 21, 2020 11:43 AM
To Next Page
Loading...
