Power Pack and Charging
5.6
Using the Quick Charger
To charge using a Quick Charger:
Note: If you connect the on-board charger (see “Charging the
Power Pack”, on page 5.3) prior to connecting the Quick
Charger, it will start charging without the ON and OFF key cycle
(in step 1 and number 7).
1. Ensure that the key switch is in the ON position.
2. Ensure that the Quick Charger is unplugged and unpowered.
3. Locate the accessory charging connector (A) and remove the
protective cover.
4. Connect the Quick charger to the power pack connector (A).
5. Plug in the AC Power Cord to an AC power outlet. Always
connect the charger to a GROUNDED outlet. When using an
extension cord, avoid excessive voltage drops by using a
grounded, 3-wire, 12-AWG cord no longer than 25 ft (7.6 m).
The charger can be used on 120 V AC or 240 V AC current.
The voltage does not change the amount of time that the
motorcycle takes to charge.
6. Connect the AC Power Cord to the AC Power Cord
Connection on the off-board accessory charger. See “Quick
Charging (Off-Board Accessory Charger)”, on page 5.5.
7. The green charge LED on the dash will begin blinking
steadily to indicate charge flow. If the key switch was turned
to the ON position, now turn it to the OFF position.
8. When the green charge LED becomes solid or the SOC reads
100%, the battery system is fully charged, disconnect the
charger. When the power pack is fully charged, disconnect
the charger(s) and reinstall the protective cover in order to
reduce water ingress, which can trigger dash warning lights.
Zero Owner's Manual (S and DS).book Page 6 Monday, September 21, 2020 11:43 AM
To Next Page
Loading...
