11
4.6 REMOTE CONTROL
The remote control is battery operated and will require two AA batteries
to use. To access and open the battery door, you will need to unfold the
hand sticks. Then place the two batteries in the correct positions and
close the battery door. To Power On the remote control, slide the Power
On button to the right. To Power Off, slide the button to the left.
NOTE:
• Insert the batteries in the correct orientation.
• DO NOT charge non-rechargeable batteries. The transmitter needs two charged
and working AA batteries to operate.
• DO NOT mix old and new batteries. This may compromise the power of the remote
control.
• DO NOT use a combination of batteries. Only use one type being either 2 x Standard
(Carbon zinc batteries), 2 x alkaline batteries or 2 x rechargeable (Nickel-cadmium
batteries).
• Always fully charge rechargeable batteries before using them. The remote control
does not charge them during use.
• Children should handle rechargeable batteries with adult supervision.
• Always remove empty batteries from the remote control to avoid confusion for use
on the next flight.
• DO NOT short circuit the supply terminals.
5.0 REMOTE CONTROL FUNCTIONS
5.1 SWITCHING BETWEEN FLIGHT MODES
To choose which mode to fly your Drone in, switch the GPS button to
either the ON or OFF positions. The ON flight mode
is shown on the
LCD display.
* AA Batteries are not included
NOTE:
• GPS Mode is recommended for outdoor
flying
• Optical Flow is recommended for Indoor
flying. Indoor flying may have weak GPS
Signal which can cause damage if the
drone is continued to be flown in GPS
mode.
To Next Page
Loading...
Need help?
General
