Power Pack and Charging
5.4
Installing the power pack(s)
Note: If you are installing and operating the motorcycle
using a single power pack, the power pack must be
installed in the position closest to the front of the
motorcycle.
1. Slide the power pack into the frame.
2. Install the power pack connector plug if only a single
power pack is installed. Failure to install the connector
plug will prevent the motorcycle from operating.
3. If you are installing a second power pack, remove the
power pack connector plug from the first power pack
and securely store it using the strap located under the
seat.
4. Slide the second power pack into position on the frame
and make sure the power pack connectors correctly
engage.
5. Re-attach the power pack rail.
6. Push the key lock upward to secure the rail.
7. Use the key to lock the rail.
8. Turn the key switch to the ON position and check that
the motorcycle has power.
CAUTION: Do not operate the motorcycle without the
power pack rail or rail fastener in place.
Zero Owner's Manual (FX and FXS).book Page 4 Tuesday, October 23, 2018 1:54 PM
To Next Page
Loading...
