Power Pack and Charging
5.10
7. The green charge LED on the dash will begin blinking
steadily to indicate charge flow. If the key switch was
turned to the ON position, now turn it to the OFF
position.
8. When the green charge LED becomes solid or the SOC
reads 100%, the battery system is fully charged,
disconnect the charger. When the power pack is fully
charged, disconnect the chargers and reinstall the
protective cover.
Note: If Quick Charger will be used again, cut access flap
(see dashed line (B)) in flexible protective cover before
re-installation. Do not cut across the top of the flap. Do not
completely remove flap.
Zero Owner's Manual (FX and FXS).book Page 10 Tuesday, October 23, 2018 1:54 PM
To Next Page
Loading...
