ZEROXCLUB INSTRUCTIONS MANUAL
• Use correct safety equipment when working at elevated levels
• Ensure correct polarity of 12V DC power supply to the camera.
Red = Positive.Black=Negative.
• Do not allow water to enter the LCD Display.
• Excessive heat can be caused by a loose connection.
2.2 Make an Installation Plan
We recommend that you make a plan before you begin the installation of
your system components. This approach will eliminate the likelihood of
running into problems with cable routing, camera mount locations, and
power supply.
* Please test the system before installation with temporary mounting
and wiring to make sure it can work well. (the method of powering the
monitor and cameras refer to 2.5)
2.2.1 Suggested Installation Sequence
Based on our experience, we recommend that you follow this installation
sequence:
Assemble Installation Tools
Install the Monitor
Connect Monitor to the Power Supply
Install the Cameras
Connect Cameras’ Red&Black Wire(s) to the Power Supply
Test and Calibrate the System
Adjust the Camera Views
Secure the Cameras’ Power Co
2.3 Monitor Installation
The monitor is delivered with a metal U-shaped bracket.
To assemble the monitor: attach the cradle using the four knob bolts.
Attach two bolts to each side by passing them through the supplied ABS
guide bushings and screwing them into the monitor.
It also contains a Fan-shaped bracket, you can choose one according to
To Next Page
Loading...
Need help?
General