Need help?Do you have a question about the Zeversolar Zeverlution Pro 33K. and is the answer not in the manual?
Details the steps required to change the default grid code setting of a Zeversolar three phase inverter.
States requirements: inverter installed, installation manual read and fully understood.
Essential to ensure correct grid code/safety setting based on serial number suffix during commissioning.
Explains when grid code needs changing if inverter is not in the default region or for specific countries.
Lists specific inverter models this guide applies to: Evershine TLC, Eversol TLC, Zeverlution Pro 33K.
Guide covers inverters with 'Basic'/'Advanced' settings; alternative 'Safety Setting' access described.
Step-by-step guide on how to navigate menus and set the grid code on the inverter.
Provides contact details for Zeversolar's Technical Sales Manager – Europe.
General| Number of MPPTs | 3 |
|---|---|
| Nominal AC Voltage | 400 V |
| THDi | <3% |
| Protection Class | IP65 |
| Operating Temperature Range | -25°C to +60°C |
| Weight | 43 kg |
| AC Voltage Range | 310 V - 480 V |
| Nominal AC Frequency | 50 Hz / 60 Hz |
| European Efficiency | 98.3% |
| Ingress Protection | IP65 |
| Max. DC Voltage | 1000 V |
| Cooling | Smart cooling |
| Maximum DC Input Voltage | 1000 V |
| Rated AC Output Power | 33000 W |
| Cooling Method | Smart active cooling |
| Humidity Range | 0 - 100 % (Condensing) |
| Communication | RS485, Ethernet |
To Next Page