Zhiyun CRANE 2 - Balance Adjustment on Roll Axis

12
Balance Adjustment on Tilt Axis
Balance Adjustment on Roll Axis
The balance status of the stabilizer will greatly affect the run time.
Loosen the thumb screw (rotate about 3 times); Adjust the tilt axis until the camera
can stay still with the lens facing up (i.e. the camera stays still and vertical to the
ground), complete this step by tightening up thumb screw.
Loosen the thumb screw on the roll axis. Adjust the roll axis until the camera can
stay still while keeping the horizontal arm level. Complete this step by tightening
up thumb screw.
Balance Adjustment