13
Balance Adjustment on Pan Axis
Loosen the thumb screw on the pan axis. Adjust the pan axis until the camera
can stay still while keeping the vertical arm level when turned to the right/left side.
Complete balance adjustment by tightening up all thumb screws.
If the camera installed is too light that
it's impossible to achieve balanced
adjustment, please purchase the
dedicated counterweight (100g)
provided by ZHIYUN and install it under
the camera mounting plate to finish
balance installation.
Balance Adjustment
If the camera hinders the rotation of the
screw, please pull out the screw before
rotating.
To Next Page
Loading...
