9.2.1.5 Electrical connection
The connection of the bus cable takes place at the slot X-CAN of the frequency inverter.
Connection CAN
9.2.1.6 Activating the interface
The activation of the CAN interface can be set in the menu Control system/CONFIG.
Control
|
-
" CONFIG 01:BP_DCP1
|
-
" 02:BP_DCP2
Configuration
The INFO menu shows CAN information at the pages 14 - 17 (Assumption: "CONFIG" = "02:
ZA_CAN").
9.2.1.7 Operation modes
Information
For the ZETADYN 3 are two operation modes by using CAN:
•
Velocity Mode (Velocity Mode [pv])
Velocity Mode
Original operating instructions
ZETADYN 3C Serial communication
R-TBA08_03-GB 1619 Part.-No. 00163322-GB
6
9/204
To Next Page
Loading...
Need help?
General
