Zimmer Hall MicroChoice System - Page 48

46
Wiredriver/Fixation Drill:
Selection of the appropriate attachment.
1. Place the Selector Switch in the "safe" position.
2. Secure the appropriate attachment to the handpiece.
3. Depress the Mode Select
Button twice, within two
seconds. The WIRE DRILL
HTQ PIN menu will display
(WIRE will be blinking).
Depress the Mode Select
Button until the desired
function is blinking.
Discontinue pressing.
4. The selected function will display with the maximum speed setting
(blinking). Depress the Mode Select Button until the desired speed is
displayed. Discontinue pressing.
5. The Controller will display the selected function and SAFE ON.
6. Move the Selector Switch to the Forward or Reverse position. The
attachment and maximum rpm will be displayed.
Warning: Make sure the head attachment matches the function
selected. Improper head selection may cause erroneous speed or torque.
Caution: The Irrigation Pump is inoperable with the Wiredriver/
Fixation Drill, Micro E
®
and the Pencil Grip Wire Driver.