7
Installation instructions
805845UK v1.02 July 2018 - G4 Command Centre
Technical support
Tel: 0345 6 005 005 Email: service@zipindustries.co.uk www.zipwater.co.uk
WARNINGS AND REGULATORY INFORMATION
Warnings
• The Zip HydroTap
G4 must be earthed. The resistance of the earth
connection from each exposed metal part must be less than 1Ω.
• All installation and service work must be completed by trained and
suitably qualified tradespeople. Faulty operation due to unqualified
persons working on this product, or any other Zip product may void
warranty coverage.
• As the installer, it is your responsibility to supply (if necessary)
and install all valves as required by local regulations and relevant
standards.
• The HydroTap
G4 is rated for 230V 50/60Hz AC operation (supply
frequency dependant upon model purchased).
• Do not remove the cover of the appliance under any circumstances
without first isolating the appliance from the power supply.
• Never locate the Command Centre near, or clean with water jets.
• Do not expose the Zip HydroTap
G4 to the elements of nature.
• Due to the process of continuous improvement, Zip reserves the right
to change details mentioned in this manual, without notice.
• Visit www.zipwater.co.uk to ensure you have the latest copy of this
document.
IMPORTANT SAFETY INSTRUCTIONS
Positioning
It is important to ensure the Command Centre is positioned in an accessible area close to the floor level. The
Command Centre
must have its base mounted in a horizontal position with all inlets and outlets facing up.
The tap must be located above the Command Centre. See Section 7, Command Centre installation.
To Next Page
Loading...
