22
Quick Start Installation Guide
807119 v1.08 05.23 G5 BCS Quick Start Guide
SECTION 12: Install the CO cylinder and regulator
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
until you feel the initial resistance to rotation, then turn a 1/2 turn further.
Repeated residential bottle changes or overtightening could eventually
wear the internal seal. If a leak occurs between the bottle and the tightened
regulator, a replacement seal may be required. A spare seal is supplied with
all residential regulators. A washer/seal kit (part no. 95267) is available if
required.
• For the 1.2kg cylinder and Universal G5 regulator use the adaptor supplied.
• Connect the gas hose to the Command Centre (see section 13).
Do not proceed if the seals are damaged.
Take care not to cross thread the regulator; a cross threaded
regulator poses a potential hazard.
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
a
b
a
b
CO Gas
hose
CO Gas
hose
1.2kg cylinder
2.64kg cylinder
Regulator
Cylinder valve
Regulator
adaptor*
*The regulator adaptor is only required for the Universal G5 regulator.
Approved regulators
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
Approved regulators
To Next Page
Loading...
