38
Quick Start Installation Guide
807119 v1.08 05.23 G5 BCS Quick Start Guide
SECTION 14: Commissioning
RE-INSTALL FILTER
12:12 PM
Step 1.
If the below steps have not been completed.
Follow the instructions below.
Step 2.
Ensure cloth is below HydroTap Clean can (2).
Remove can (2) from HydroTap Clean adapter (1).
• This screen is shown after completion of
the boiling calibration and or cleaning
processes.
• Unscrew the HydroTap Clean can (2).
• Ensure to hold the adapter in place while
unscrewing the can.
RE-INSTALL FILTER 12:12 PM
Step 3.
While Boiling Calibration in Progress....
Step 4.
Remove adaptor (1) from filter head.
Re-install filter. Dry any water under filter.
RE-INSTALL FILTER
12:12 PM
Step 3.
If the below steps have not been completed.
Follow the instructions below.
Step 4.
Remove adapter (1) from filter head.
Re-install filter. Dry any water under filter.
• Remove the dust cap and re-install the
filter.
• Touch forward arrow on screen to
continue.
• Remove the HydroTap Clean adapter (1)
from filter head.
To Next Page
Loading...
