STEP 6.
Install stabilising pads for pedal bases
(55L/R) on handle arms (7L/R) and pedal
bases (8L/R) using bolts (35).
Fix the left and right handle (6L/R) to
the left and right handle arm (7L/R) with
bolts (44), curved washers (43), and
hexagonal nuts (49).
STEP 7.
Install the water bottle holder (67) on
the handlebar column (4) using the bolt
(68) and the flat washer (69).
Make sure the holder is secure and insert
the bottle.
STEP 8.
Plug in the power supply unit (54) and plug
the cable into the power socket on the
front of the mainframe.
Congratulations! You have assembled elliptical trainer!
Read the manual carefully before using the elliptical trainer.
ADJUSTMENTS
Handlebar
Loosen the handlebar adjustment knob. Set the handlebar in the desired position and tighten the knob.
Make sure the handlebar is secured.
Pedal position
Unscrew pedal bolts from the pedal base. Set the pedals in the desired position and tighten the bolts. Make
sure the pedals do not move.
Stride height
The stride height is adjusted with trainer arm lengths. Loosen the arm adjustment knob. Set the desired
length and tighten the knob. Set the other arm the same way. Make sure the arms do not move.
MAINTENANCE
Carry out maintenance activities at regular intervals.
The tasks listed below should be carried out at least every 20 hours of operation.
• Check moving parts of the device. If they need lubrication, use a bicycle bearing grease.
• Check the conditions of such parts as bolts and nuts. Make sure they are tight.
• Wipe the sweat off the device after each training. Make sure the display does not come in contact
with water or moisture.
• Clean the product with soapy water only. Do not use cleaning agents.
To Next Page
Loading...
