4. Install the handlebar
Run the heart rate measurement cable through
the handlebar post (59) and through the computer
bracket opening.
Fix the handlebar (55) to the handlebar post (59) using
hexagonal bolts (54), flat washers (340).
Fix the handlebar cover (53).
5. Install the computer
Connect the heart rate measurement cables (56)
and the connecting cable from the top
of the handlebar post (59) to computer cables (52).
Fix the computer (52) to the handlebar post (59) using
the bolts M5x10 (62) and washers (61).
6. Install the water bottle holder
Install the water bottle holder (47) on the handlebar
post (59) using the bolt (45) and the flat washer (46).
Make sure the holder is secure and insert
the bottle.
Congratulations! You have assembled elliptical trainer!
Read the manual carefully before using the elliptical trainer.
ADJUSTMENTS
Resistance adjustment
In order to increase the resistance, turn the resistance knob clockwise. In order to decrease the resistance,
turn the resistance knob counterclockwise.
Pedal position
Unscrew pedal bolts from the pedal base. Set the pedals in the desired position and tighten the bolts. Make
sure the pedals do not move.
MAINTENANCE
Carry out maintenance activities at regular intervals. The tasks listed below should be carried out at least
every 20 hours of operation.
To Next Page
Loading...
Need help?
General
