Summary
* Please ensure correct
placement of fi nger on
reader.
* 125 MHz RFID Cards can
be used.
* Do not install in direct
sunlight or bright light
* 0–50°C for optimal perfor-
mance
* Shut down the unit and
power before attempting
maintenance
1. Instructions
1.1 Instruction for Card Swipe
This device is supplied with an integrated non-contact RFID (125 MHz) card reader mod-
ule. By offering multiple verifi cation modes such as, RF card, pin, RF card verifi cation +
pin. This device can accommodate diversifi ed user needs.
Swipe your card across the sensor area after the voice prompt and remove your card
after the device has sensed it. For the swipe area, see 2.2 Product Appearance.
1.2 Precautions
Protect the device from exposure to direct sunlight or bright light, this greatly affects the
terminal and leads to verifi cation failure.
It is recommended to use the device under a temperature of 0–50°C so as to achieve
the optimal performance. In the event of exposure of the device to the outdoors for
long periods of time, it is recommended to adopt sunshade and heat dissipation facili-
ties because excessively high or low temperature may slow down the device operation
and result in high false rejection rate (FRR).
When installing the device, please connect the power cable after connecting other
cables. If the device does not operate properly, be sure to shut down the power supply
before performing necessary inspections. Note that any live-line working may cause
damage to the device and the device damage arising out of live-line working falls be-
yond the scope of our normal warranty.
For matters that are not covered in this document, please refer to related materials
including the installation guide, access control software user manual.
1.3 System Specifi cations
SPECIFICATION
Transaction Capacity: 100 000 transactions
Hardware Platform: ZEM500
Built-in Card Reader: 125 Mhz RFID Reader
Communication: RS232/485, TCP/IP,USB-host
Wiegand Ports: Input and Output any bits
Access Control interfaces: 3rd party electric lock,
door sensor, exit button,
open door alarm.
Access Control functions: 50 time zones, 5 access
control groups, 10 unlock
combinations
3
To Next Page
Loading...