What to do if the POWER indicator is not on and the button is not responding on ZKTeco CMP-200 Automatic Barriers?
If the POWER indicator of your ZKTeco Automatic Barrier is off and the button doesn't respond, it could be due to the power supply not being connected. In this case, connect the power. Alternatively, the fuse might have blown off, so replace the fuse.
Why is the remote-control handle not responding on ZKTeco CMP-200?
If the remote-control handle for your ZKTeco Automatic Barrier isn't responding, the battery of the handle might be low. Try replacing the battery. If that doesn't work, the handle itself might be broken, and you should replace it.
What to do if the POWER indicator is on but there is no response by remote control for ZKTeco CMP-200?
If the POWER indicator is on, but the remote control isn't responding on your ZKTeco Automatic Barrier, it could be due to a few reasons. First, the remote-control code might be wrong; try recoding it. Second, the receiving module might be poor; consider replacing it. Finally, there might be same frequency interference; try changing to other frequencies.
Why is ZKTeco Automatic Barriers unable to rise or fall boom to limit?
If your ZKTeco Automatic Barrier boom is unable to rise or fall to the limit, the limit line might be misconnected. Reconnect the rising and falling limit line. Alternatively, the limit switch could be broken, so replace the limit switch.
What to do if the POWER indicator is on, the boom UP and DOWN indicator is normal, but the motor is not running on ZKTeco CMP-200 Automatic Barriers?
If the POWER indicator is on, the boom UP and DOWN indicator is normal, but the motor isn't running on your ZKTeco Automatic Barrier, it could be that the motor wire is open or incorrectly connected. Connect the motor wire. It's also possible that the motor is stuck, so manually release the motor.
Displays the physical appearance and key dimensions of the barrier gate.
Important considerations and warnings before installing the barrier gate.
Details on how to properly route and embed cables for the barrier gate.
Step-by-step guide for installing the boom arm onto the barrier gate.
General| Brand | ZKTeco |
|---|---|
| Model | CMP-200 Series |
| Category | Automatic Barriers |
| Language | English |
To Next Page
