MB10-VL User Manual
Page | 40 Copyright©2021 ZKTECO CO., LTD. All rights reserved.
Fingerprint Parameters
Select Fingerprint option on the System interface.
Item Descriptions
1:1 Threshold
Value
Under 1:1 verification method, the verification will only be successful when the similarity
between the acquired fingerprint data and the fingerprint template associated with the
entered user ID enrolled in the device is greater than the set threshold value.
1:N Threshold
Value
Under 1:N verification method, the verification will only be successful when the similarity
between the acquired fingerprint data and the fingerprint templates enrolled in the
device is greater than the set threshold value.
FP Sensor
Sensitivity
To set the sensibility of fingerprint acquisition. It is recommended to use the default level
“Medium” in normal conditions
. When the environment is dry, resulting in slow
fingerprint detection, you can set the level to “High” to raise the sensibility; when the
environment is humid, making it hard to identify the fingerprint, you can set the level to
“Low“.
1:1 Retry
Attempts
In 1:1 Verification, users might forget the registered fingerprint, or press the finger
improperly. To reduce the process of re-entering user ID, retry is allowed.
Fingerprint
Image
To choose whether to display the fingerprint image on the screen during fingerprint
enrolment or verification. Four choices are available:
Show for enrol: To display the fingerprint image on the screen only during enrolment.
Show for match: To display the fingerprint image on the screen only during verification.
Always show: To display the fingerprint image on the screen during enrolment and
verification.
None: Not to display the fingerprint image.
FRR FAR
Recommended matching
thresholds
1:N 1:1
High Low 45 25
Medium Medium 35 15
Low High 25 10
To Next Page
Loading...
Need help?
General
