ZKTeco PL10 - Initialize Lock; Operating Steps; Indication of the Lock

5
Initialize Lock
Method 1 Method 2
Press the "Reset" button with
a pin.
Touch the infrared sensor hole
to power on the lock
Loosen the pin.
Press the button of "+", "1",
"2", "3" , "-".in order
Initialization succeed
One beep for each
pressing, back LED
blinks green
Fingerprint sensor is
power on LED blinks
green
A long beep, LED blinks
green for 1 second
Operating Steps
Indication of the lock
Operating Steps
Delete all Normal Users
Delete all Admin Users..
Reset successfully
Please see “Delete
Temporary Users”.
Delete all Temporary
Users.
Please see “Delete
Normal Users”.
Please see “Delete
Admin Users”.
Note: The lock will be restored to factory defaults after initialization, and the door can be opened
with any fingerprint.