Click > [Comm.] > [Ethernet] to set the network parameters. If the TCP/IP communication of the
device is successful, the icon will be displayed in the upper right corner of the standby interface.
Click that is, the IP > [Comm.] > [Cloud Server Setting] to set the server address and server port,
address and port number of the server after the software is installed. If the device communicates with
the server successfully, the icon will be displayed in the upper right corner of the standby interface.
13 Ethernet and Cloud Server Settings
Main Menu
User Mgt.
User Role
COMM.
System
Data Mgt.Personalize Attendance
Search
Autotest
System Info
Access Control
192.168.163.150
0.0.0.0
4370
255.255.255.0
192.168.163.1
IP Address
Subnet Mask
Gateway
DNS
TCP COMM. Port
DHCP
Display in Status Bar
Ethernet
Note:
When using the ZKBioSecurity MTD software, make sure that the option Enable Domain Name is
disabled and input the correct server address and port.
Server Address: Set the IP address of the ZKBioSecurity MTD server.
Server Port: Set the service port of ZKBioSecurity MTD (The default is 8088).
14 Access Control Settings
Click to enter the access control management interface and set the relevant > [Access Control]
parameters of access control.
ADMS
8081
0.0.0.0
Server mode
Enable Domain Name
Server Address
Server port
Enable Proxy Server
Cloud Server Setting
HT TPS
12