7
Preparing the Refrigerator Enclosure
IMPORTANT SAFETY INSTRUCTIONS
Preparing the Refrigerator Enclosure
IMPORTANT SAFETY INSTRUCTIONS
ATTENTION
Failure to follow these instructions may result in death, fire, or electric shock.
Connecting the grounding conductor of the equipment to an improper
place may lead to electric shock. Please have the grounding checked by a
qualified electrician or service technician.
Installation, repair, and other procedures performed by unqualified
persons may cause danger. Before installing the appliance, make sure that
the voltage, load, and circuit current parameters on the data plate are in
compliance with the power mains in your house.
The appliance is provided with a NEMA 5-15P plug and a 3-pin power
cable, which is in the UL list and ready to be connected to a 120VAC, 60Hz
power supply. The fuse is 15 amps, and the appliance must be connected to
a dedicated electrical outlet.
If combining two RBIV-30 units into an RBIV-60 model, ZLINE recommends
both be plugged into independent circuits. They can be plugged into the
same outlet, but the circuit must have a dedicated 15-amp breaker.
If the electrical wiring or power supply of the house needs alteration,
the necessary procedures must be performed by a qualified electrician.
The plug must be installed only by a licensed electrician.
CABINETS
• Make sure that the cabinets where you will install the appliance have been safely mounted in
your kitchen. Your cabinets must be securely connected to the floor and walls properly and
with suitable connections.
• For the best installation, clearances between the cabinets and the product must be in
compliance with the values specified in the installation instructions of this manual.
• Side walls must be free of any obstructions and their surfaces must be flat.
• NOTE: Minimum thickness of the side walls is 5/8" (16 mm). The minimum thickness of the
doors to be attached to the product must be 3/4" (19 mm).
To Next Page
Loading...
