3) Display Settings
[Display Settings] In order to configure the [Display Settings] for the NVR, go to [Main Menu], then to
[Settings], and then select [Display].
[Channel]: This is the current channel you are editing the settings for.
[Channel Name]: This is the name you want the NVR to display for the selected channel.
[Channel Display]: Whether or not to display the channel name on the live feed.
[Time Display]: Whether or not to display the time on the selected channel.
[Resolution]: This is the video output resolution for the NVR.
WARNING: Do not set this too high for your monitor. You may permanently lose access to the menu
system on the NVR.
[Enable AUTO SEQ]: Whether or not to enable auto sequencing between channels.
[All]: Whether or not to include all channels in the Auto Sequence.
[View 1CH]: Whether or not to view the selected channels in full screen mode during auto sequence
[View 4CH]: Whether or not to have a 4 CH grid view during the auto sequence.
[Interval]: The length of time you want the NVR to pause on each selection in the auto sequence.
To Next Page
Loading...