ZMODO NVR - Zviewer for iOS; Device Management in iOS App; Connecting to iOS Device

3.2 Zviewer for iOS
[Zviewer for iOS]
Figure 1 Figure 2
Figure3 Figure 4
Device Management:
1. From the home screen (Fig1), press the
settings arrow in the bottom left and select
“Device Manage”(Fig2).
2. From the management screen( Fig3), select
the “+” icon in the upper right hand corner
to add a device.
3. From the “Add Device” page (Fig4), enter a
name for the DVR. Now enter the
corresponding IP address, mobile port
number, case sensitive username and
password, and the number of channels your
DVR has. Change the current channel to “2”.
4. Select “save” to save your device. (Note:
Greyed out values must have something
input before you will be able to save.
Connecting to a Device
1. From the home screen (Fig1) select 1 of the 4
windows so that an orange highlight is around the
perimeter of the box.
2. Press the settings arrow in the bottom left and select
“Connect to Device” (Fig2).
3. From this device list, you may select your device
from the list. After selecting your device, you may
choose a channel to play. This will play your camera
in the box previously selected in step 1.
4. Repeat steps 1 through 3 up to four times. Each box
may be connected to either the same or separate
devices from the list and be controlled
independently